The NI myDAQ student data acquisition device is designed to give students the ability to work on engineering course work and experiment with projects hands-on anywhere, anytime. The myDAQ is a high-quality instrumentation device that gives students the power to prototype systems and test circuits outside of the classroom and improve comprehension with continuous reinforcement. (This version of the myDAQ is only for sale to students in the USA).

Special Offer: Optional accessory -  myGRID for NI myDAQ - an AC power grid that helps to investigate the components of a power grid - is available as a bundled purchase - click the checkbox below - while supplies last.

Special Offer: Optional accessory -  myGRID for NI myDAQ - an AC power grid that helps to investigate the components of a power grid - is available as a bundled purchase - click the checkbox below - while supplies last.

Programmable Xilinx 7020 FPGA NI ELVIS—The NI Engineering Laboratory Virtual Instrumentation Suite (NI ELVIS) III is an engineering laboratory device developed for project-based learning.

NI Circuit Design Suite combines Multisim 14.3 and Ultiboard software, to offer students a complete set of tools for circuit design, simulation, validation, and layout. The Circuit Design Suite software download helps you design circuits using intuitive and cost-effective tools.

Note: (Only for sale to Students & Faculty in the USA for lab preparation on personal computers, not for classroom or institutional use.)

The National Instruments myRIO-1900 is a portable reconfigurable I/O (RIO) device that students can use to design control, robotics, and mechatronics systems.
 

For motor control, use the MD2 Motor Driver